![]() Trim and heat shrink the legs of the new resistor (if you're using tape, wait until after you've soldered the resistor down, then just tape around the whole thing).Ĥ. There are also more photos available on the previously mentioned thread.ģ. Double-clicking the photos here will take you there) Locate the points you need to solder to (Look at the 2 photos below, larger photos are available on the Roadside Guitars Flickr. A 500K (approximate values are fine) 1/4 watt resistorĢ. Note that the slow speeds are still available.ģ. I would say though, that this mod, being as simple and easily reversible as it is, is practically a must try for any CS-9 owner. It does give way to some pretty good rotary speaker-like sounds at the newly available higher speeds, but obviously still doesn't touch standing in front of a Leslie. There's a lot of hype surrounding this on the thread I linked to. I personally used a 470K resistor instead of the recommended 510K and it worked fine. I found this mod on Here is a link to the seminal thread: This modification works by adding a resistor to the underside of the circuit board in parallel with an already present resistor effectively dropping the original part value, and changing the circuit to allow faster rates, resulting in a pseudo rotary speaker type of sound at some settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |